Filter
Top Products
28
2 REC MODE SET
INTRODUCTION OPERATION SETTINGS OTHER OTHER OTHER OTHER
1 Press the [MENU] button.
The [MENU] button lights, and the <MAIN MENU> screen
appears.
2 Select “2. REC MODE SET”, and press
the [ ] button.
The <REC MODE SET> screen appears.
3 Press the [ ] and [ ] buttons to select
the desired item, then press the [ ]
button.
4 Press the [ ] and [ ] buttons to
change the setting, then press the
[ ] button.
5 Use the same procedure to set the other
items as needed.
6 When you have finished making the
settings, press the [EXIT/OSD] button.
The display returns to the normal screen.
When “OVER WRITE” is set to “OFF” and the hard disk
becomes full, the FULL indicator lights and recording stops.
To start recording again, first follow the steps below to
erase the images recorded so far.
1 Display the <REC MODE SET> screen.
2 Press the [ ] or [ ] button to select
“DISK FULL RESET”, then press the
[ ] button.
The <WARNING> screen appears with “NO” flashing.
3 Press the [ ] or [ ] button to select
“YES”, then press the [ ] button.
The images recorded so far are erased, and the display
returns to the normal screen.
The FULL indicator goes out, and you can record again
until the disk becomes full.
Settings
SEARCH
MENU RESET
MENU
REVIEW
CUE
EXIT/OSD
PLAY/
STOP
STILL
[ ] button[MENU] button [ ] button
[ ] button [EXIT/OSD] button
Starting recording again when the
FULL indicator lights
ALARM
REC/STOP
LOCK/REMOTE
USB
POWER
SEARCH
MENU RESET
MENU
REVIEW
CUE
EXIT/OSD
PLAY/
STOP
STILL
TIMER
FULL
LAN
(LINK/ACT.)
[ ] button [ ] button
[ ] buttonFULL indicator
e_dsr_m800.book Page 28 Friday, January 31, 2003 5:45 PM