Filter
Top Products
Routing the cables
When connecting cables from your SMARTUF75 projector to your interactive whiteboard system,
make sure that all cables pass along the top of the interactive whiteboard wall-mounting bracket and
then down the side of the interactive whiteboard.
When connecting cables from a SMARTUF75w projector to the interactive whiteboard, make sure
that all cables pass between the two interactive whiteboard wall-mounting brackets. Space your wall-
mounting brackets 4" (10.2 cm) apart to provide full support for the weight of your interactive
whiteboard.
Cable routing for SMARTBoard 660 and 680
interactive whiteboards
Cable routing for SMARTBoard 685 and 690
interactive whiteboards
I I MPORTA NT
Do not connect the power cable to a power outlet until you have connected all the cables to the
projector and ECP.
Installing SMART software
You must install SMARTsoftware on the computer connected to your interactive whiteboard system
to access all of its features.
Download SMARTsoftware from smarttech.com/software. These pages list the minimum hardware
requirements for each software version. If SMART software is already installed on your computer,
take this opportunity to upgrade your software to ensure compatibility.
C HA PTER 2
Installing your interactive whiteboardsystem
9