Filter
Top Products
Setting Use Notes
Projector Functions menu
3D On/Off Turns the DLPLink technology 3D
feature on or off.
The default is off.
3D Format Displays the current 3D format
(Interleaved or Under-over).
Interleaved breaks down the image
frame for each eye, alternately
displaying a line of visual information
from each frame.
Under-over concurrently displays
horizontally stretched image frames for
each eye, one above the other.
3D Invert
Left-Right
Selects the 3D Invert setting (L-R or
R-L).
L-R displays visual data for the left eye
first.
R-L displays visual data for the right
eye first.
Auto Signal Detect Enables or disables signal searching of
input connectors.
The default is off.
Select On to have the projector
continuously switch inputs until it finds
an active video source.
Select Off to maintain signal detection
in one input.
Lamp Reminder Turns the lamp replacement reminder
on or off.
This reminder appears 100 hours
before the recommended lamp
replacement.
Lamp Mode Adjusts lamp brightness to Standard
or Economy.
Standard displays a high-quality,
bright image.
Economy increases the lamp life by
decreasing the brightness of the image.
Auto Power Off
(minutes)
Sets the length of the auto power-off
countdown timer between 1 and 240
minutes.
The default is 120 minutes.
The timer begins to count down when
the projector no longer receives avideo
signal. The timer finishes when the
projector enters Standby mode.
Select 0 to turn off the timer.
Zoom Adjusts the zoom to the center of the
image in or out from 0 to 30.
The default is 0.
Zooming in cuts off the outer edges of
the source video.
Projector ID Sets the projector’s unique ID number
(from 0 to 99) within your organization’s
network.
You can refer to this number when
using the network remote management
feature (see Remotely managing your
system through a network interface on
page 57).
C HA PTER 3
Usingyour interactive whiteboardsystem
16