Filter
Top Products
Projector programming commands
This section documents the projector programming commands.
Projector power state controls
Your projector responds to commands only at certain power states and times.
There are five projector power states:
l Powering (startup)
l On (operating)
l Cooling
l Confirm off
l Idle (Standby mode)
Command inventory
Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector’s current power state, type ? and press ENTER.
I I MPORTA NT
When entering commands, ensure there is a 10 millisecond delay between characters for reliable
operation.
N N OTES
l Send a command only after the projector sends a command prompt.
l Commands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
l Check your entries carefully before entering your commands.
l Press ENTER after typing each command.
l After the projector executes acommand, it generates aresponse.
l To prevent buffer overrun, don’t send another command until you receive the next command
prompt.
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
70