Filter
Top Products
g To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module.
Hold the lamp module vertically and guide it into its slot. Gently press the power end of the
lamp module against the projector to ensure the power plug makes contact with the projector’s
power receptacle.
N N OTE
You should be able to place the lamp module into the projector easily without applying much
force.
3. Use the Phillips screwdriver to secure the captive screws.
I I MPORTA NT
Do not over-tighten the screws.
4. Carefully replace the lamp cover.
5. Connect the power cable to the wall outlet.
6.
Press the Power button once on the remote control or ECP to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp module in a secure container, and handle it gently until you recycle it.
g To finish the projector lamp module installation
1. Turn on the projector.
2. Adjust the projector image if necessary (see Adjusting the image on page 23).
3. Access the service menu to reset the lamp hours (see Resetting the lamp hours on next page).
C HA PTER 5
Maintainingyour interactive whiteboardsystem
40