Filter
Top Products
A P P E N D I X B
Remotelymanagingyour interactiveflatpanel
86 smarttech.com/kb/170446
Room control system programming commands
and responses
To access interactive flat panel information or to adjust interactive flat panel settings using the room
control system, type commands after the command prompt (>), and then wait for the response from
your interactive flat panel.
C OR R E C T
>get contrast
contrast=55
If you type a command that the room control system doesn’t recognize, you receive an invalid
command response.
In the example below the user included a space in the contrast command.
I N C O R R E C T
>set con trast=65
invalid cmd=set con trast=65
N OT E S
l Use ASCII formatted commands.
l Commands aren’t case-sensitive.
l Review each entry carefully before you press ENTER.
l Don’t send another command until you receive the response and the next command prompt.
Command inventory
Your interactive flat panel responds to the commands in the tables on the following pages. To see a
list of valid commands for your interactive flat panel’s current power state, type ?, and then press
ENTER.
Identifying current values
You can identify the current value for each setting. In the example below, the user wants to identify
the contrast level for the interactive flat panel.
>get contrast
contrast=55