Filter
Top Products
Chapter 6 Setup Operations
6-4 Chapter 6 Setup Operations
6-3 Setup Menu Settings
Setup menu settings (Continued)
Top menu
item
Submenu items (nested
submenus in angle brackets)
<AUDIO> INPUT 1/2 Select audio input for channels 1
and 2 when digital video input is
selected.
ANA: analog audio input
DIGI: digital audio input
INPUT 3/4 Select audio input for channels 3
and 4 when digital video input is
selected.
ANA: analog audio input
DIGI: digital audio input
EMPHASIS Toggle emphasis on analog audio
input.
OFF: no emphasis
ON: Apply emphasis.
DOUBLE REC Toggle simultaneous recording of
audio channels 1 and 2 on
channels 3 and 4.
OFF: Record separate signals on
channels 1/2 and 3/4.
ON: Record same signals on channels
1/2 and 3/4.
EXIT Return to top menu. —
<SYSTEM 1> PREROLL Set the preroll time for editing
using the REMOTE connector.
0 to 10 seconds in 1 second steps
POSTROLL Set the postroll time for editing
using the REMOTE connector.
0 to 10 seconds in 1 second steps
SEARCH Select the tape speed in search
operations.
(Both forward and reverse)
X2: 2 times normal speed
X5: 5 times normal speed
X8: 8 times normal speed
P-ON REC Select whether to start recording
automatically at power on.
OFF: Do not start recording.
ON: Start recording.
EXIT Return to top menu. —
<SYSTEM 2> TC OUT Select the signal output from the
TC OUT connector.
GEN: time code produced by the time
code generator.
AUTO: during recording (including E-E
mode), the time code produced by
the time code generator; during
playback, the LTC signal from the
tape.
Function Setting values
TC DELAY Toggle the LTC phase correction
for the output from the TC OUT
connector.
OFF: no phase correction to LTC signal
AUTO: Adjust phase of LTC signal to
correspond to the video output.
REC RUN Select time code recorded when
F-RUN/R-RUN switch set to R-
RUN.
INT: time code produced by time code
generator
TAPE: time code played back from
tape
EXIT Return to top menu. —
(Continued)