Filter
Top Products
21
Installation
GB
Storing the cables in the display stand
Remove the cable cover on the display stand to store the mains lead and display interface cable.
1 Pull the top of the cable cover of the
display stand towards you to unlock it.
2 Detach the cable cover and remove.
3 Store the cables in the display stand.
Pass the cable through the centre hole. Set
the cable cover in the groove at the bottom
of the stand, and then push it shut.
The branch point of the display cable's
black and white connectors is thick,
and will not fit under the cable cover.
Arrange the branch point so that it is
outside and above the cable cover.
Rear of display
Cable cover
Branch
point
Groove at the
bottom of the
stand