Filter
Top Products
– 67 –
• Removal of anode-cap
NOTE : Short circuit the anode of the picture tube and the
anode cap to the metal chassis, CRT shield or car-
bon paint on the CRT, after removing the anode.
a
a
• removing procedures
b
b
c
2 Using a thumb pull up the
rubber cap firmly in the
direction indicated by the
arrow b.
2-6. PICTURE TUBE REMOVAL
3 Chassis assmbly
4 CV board
6 Deflection yoke
9 Demagnetization
0 Two spring
!¡ Four screws
(Tapping screw 5)
!™ Picture tube
1 Anode cap
Cushion
Cassette door
2 Two screws (+BVTP 4 X 16)
8 Two DGC clip
7 Top support
5 NA rotation coil
Note: Notice for Installing chassis assmbly
Install chassis assembly when keep
the cassette door open state.
1 Turn up one side of the
rubber cap in the
direction indicated by
the arrow a.
3 When one side of the rubber
cap is separated from the
anode button, the anode-cap
can be removed by turning
up the rubber cap and pulling
it up in the direction of the
arrow c.
• how to handle an anode-cap
1 Don't hurt the surface of anode-caps with shaped
objects!
2 Don't press the rubber too hard so as not to hurt inside of
anode-caps!
A metal fitting called the shatter-hook terminal is built into
the rebber.
3 Don't turn the foot of rubber over too hard!
The shatter-hook terminal will stick out of damage the
rubber.