Filter
Top Products
Problem: I’m not getting a picture on my TV or monitor!
Solution: There are a couple of things that could be going on. Here are a couple of theories:
• If you’ve connected the DVR to a TV via the VIDEO OUT port, ensure that the composite video
cable (BNC to RCA) connects the MAIN VIDEO OUT on the DVR to a VIDEO IN on your television.
Check that the TV is set to the right channel (AV, Channel 0, Video, Composite). Try using a
different video input on the television. Try using a different cable. If all else fails, it’s time for a
different TV!
• If you’re using a VGA monitor, check that the resolution that the DVR is outputting is less than
or equal to the maximum (or native) resolution of the monitor. You might need to connect a TV
or other monitor to change that setting on the DVR - or get a monitor which can display higher
resolutions!
Problem: My DVR does not switch on.
Solution: Make sure you have plugged in the power supply (12V) to the DVR and into the wall socket.
Carefully check the integrity of the connections. Try another power socket.
Problem: My display is showing “NO HARD DISK” when I press record.
Solution: If you have recently changed the hard drive in your DVR unit make sure it is plugged in
properly; otherwise the hard drive may be faulty. Try connecting another (working) hard drive to the
DVR; if this still doesn’t work then the DVR maybe faulty. We suggest calling Swann Technical Support.
The contact information is on the rear cover of this booklet.
Problem: I am not getting pictures from my cameras on any of my displays.
Solution: Make sure the cameras are connected properly to the DVR and their power supplies (usually
about 12V, but some cameras have different requirements - particularly when one power supply is used
for multiple cameras). Check that the cables are not the bits at fault by connecting the cameras directly
to the DVR or to a TV (if you have the proper adapters).
Problem: One of the displays is not showing on my screen.
Solution: Make sure all cameras are set to ON in CAMERA SETUP. Check the integrity of your cables and
connections. Check the power supply to the camera. Try attaching another channel to the questionable
input.
Problem: I cannot login to my DVR remotely using the Internet Explorer browser.
Solution: Make sure you have configured the IP, ActiveX and USER SETUP correctly. Remember the
USER PASSWORD may be different to the ADMIN PASSWORD. The ADMIN PASSWORD is used to login
to the DVR remotely.
Problem: I cannot copy files off the DVR.
Solution: Make sure the DVR is connected to a USB flash drive, and that the USB flash drive is formatted
to have a FAT32 file system. Some flash drives are not compatible with the DVR (these are rare) because
they use an uncommon USB device class - in these cases, try using a different USB flash drive.
Troubleshooting
37