Filter
Top Products
EN10
Before You Start
1 POWER indicator: Lights up when the power is on.
2 DVR indicator: Lights up when DVR mode is selected.
3 DVD indicator: Lights up when DVD mode is
selected.
4 I REC / OTR :Press once to start a basic recording.
Press repeatedly to start an OTR (One Touch
Recording). Each press increases the recording time by
30 minutes up to eight hours.
5 F PAUSE :Press to pause playback or recording.
6 C STOP :
Press to stop playback or recording.
7 B PLAY * : Press to start or resume playback.Press and
hold for 5 seconds to set the Progressive Scan mode on /
off.(DVD mode only)
8 Remote control sensor:Receives signals from the
remote control.
9 Display:Shows information and messages.
10 A OPEN / CLOSE * : Press to open / close the disc
tray.
11 Disc tray:Place a DVD here.
12 D/ G (SKIP/FWD) :
During playback,press to skip to
the next title, chapter,or track.
During playback,press and
hold for
2 seconds for fast forward.
When playback is
paused,
press and hold for 2 seconds for slow forward
and
press repeatedly for step by step playback.
13 H /E (SKIP/REV) :During playback,press to skip
to the previous
title, chapter,or track
During playback,press and hold for 2 seconds for fast reverse.
When playback is paused,press and hold for
2 seconds for slow
reverse and press repeatedly for step by step playback.
14 CHANNEL K / L:Press to change the channel.
15 Device select button : Press to switch the device
mode between DVR and DVD.
16 POWER: Press to turn the unit on / off. The red LED
is lit when the power is on.
POWER
DVR
CHANNEL
PAUSE STOP PLAY
OPEN/CLOSE
DVD
REC/OTR
1
16 15 13 1214
2 3 8 9 114 5 6 7* 10*
*
The unit can also be turned on by pressing these buttons.
Front Panel
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
COAXIAL
VIDEO OUT
L
R
Y
P
B/
C
B
PR/
C
R
AUDIO OUT
AUDIO IN
L
R
OUT
IN
ANTENNA
OUT
S-VIDEO
COMPONENT
VIDEO OUTPUT
VIDEO IN
L
R
2 1
17 18 19 22 23 242120
2526
17 AC Power Cord: Connect to a standard AC outlet to
supply power to this unit.
18 COAXIAL DIGITAL AUDIO OUT: Connect an AV
receiver, Dolby Digital decoder or other equipment
with a coaxial digital input jack with an audio coaxial
digital cable.
19 VIDEO OUT:Connect the video input of a TV
monitor, AV receiver, or other equipment here using
the supplied video cable.
20 COMPONENT VIDEO OUT: Connect the
component video input of a TV monitor, AV receiver,
or other equipment here using a commercially available
component video cable. (DVD mode only)
21 S-VIDEO OUT:Connect the S-Video input of a TV
monitor, AV receiver, or other equipment here using a
commercially available S-Video cable.
22 VIDEO IN(LINE1) :Connect the video output of an
external device here using the supplied video cable.
23 TV ANTENNA IN: Use to connect an antenna.
24 TV ANTENNA OUT: Use to connect an antenna
cable to pass the signal from the TV ANTENNA IN to
your TV monitor.
25 AUDIO IN(LINE1) :Connect an external equipment
here using a supplied audio cables.
26 AUDIO OUT :Connect the audio input of a TV
monitor, AV receiver, or other equipment here using
the supplied audio (L / R) cables.
Note: Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
Rear Panel
Functional Overview
E41A1CD(1-15).qx3 06.3.2 11:25 AM Page 10