Filter
Top Products
7.10 Transponder information
> Press OK to call up the navigator.
> Use the arrow keys to mark the programme for which
you wish to view the data.
> Press the Option key to display the data of the trans-
ponder selected (Fig. 7-14).
> Use the coloured function keys to also display
Audio/Video information, Programme information,
and, where appropriate, information on the encryption
system used (CA).
> Press Menu to exit from this display.
7.11 Freeze frame
> Press the Freeze frame key to freeze the current tele-
vision picture.
> Press the same key again to revert to normal opera-
tion.
7.12 Teletext
7.12.1 Using the teletext decoder of your
television set
Where broadcast, the teletext is transmitted to your television
set. To operate video text functions, use the remote control of
your television set. If you experience problems on your televi-
sion set, e.g. an overlay of video text over the picture content,
you should change the setting of your digital receiver to FBAS
mode (Point 6.3.4).
7.12.2 Using the internal video text decoder
Alternatively, you may use the integrated TOP teletext deco-
der to display the information. The TOP teletext system
groups all text pages thematically in groups and blocks,
making use of the function more easy and convenient.
> Switch to the programme on which you wish to view
video text information.
> Display the teletext by pressing the teletext key
(Fig. 7-15).
> Use the numeric keys to enter the desired teletext
page. Your selection will be displayed in the upper left-
hand corner of the screen. When you have entered the
desired teletext page number, your receiver will search
for this page.
As not all teletext pages can be transmitted simultane-
ously, it may take a few seconds for the receiver to
find the page and display it on the screen.
All teletext providers use page 100 to show their index
of contents.
28
(Fig. 7-14)
VT group VT block
(Fig. 7-15)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 28