Filter
Top Products
Starting a recording manually and ending it auto-
matically
> Switch to the channel that will broadcast the program-
me you wish to record.
> Press the Record key to record the current program-
me. The programme will continue to be displayed on
the screen while the recording is running.
> Press the On/Standby key
A prompt will appear on screen, asking you whether
you wish to record the current programme to the end.
> Use the left/right arrow keys to select Yes in order to
record the current programme to the end.
> Confirm by pressing OK.
The receiver will record the entire programme, and will
then remain in standby mode.
> If you switch on the receiver before the end of the
recording procedure, please note the messages
displayed on screen.
7.15.1.2 Timer recordings
You can use the hard drive timer to make recordings on the
integrated hard drive in your absence. In addition, your digital
receiver is equipped with a video recorder timer and a pro-
gramme change timer. As far as the programming is concer-
ned, the timer types differ only in their names.
You may programme the timers manually as described in this
chapter, or with the help of the SFI function as described in
Point 7.14.7.2.
1. Hard drive timer
This function will switch the digital receiver on and off for the
selected programme, so that this can be recorded on the hard
drive in your absence.
If the receiver was switched on by means of the hard drive
timer, this will be indicated by “ PVR Timer” being shown on
the display. Most of the remote control functions are disabled
in order to prevent an accidental premature interruption of the
recording. When the receiver is in standby mode, an active
timer will be indicated by a clock symbol shown on the
display.
2. Video recorder timer
Use the video recorder timer to switch the digital receiver on
and off for a particular programme, so that this can be recor-
ded on an external recorder, such as a video recorder, in your
absence. Please note that you must programme your video
recorder to record the programme.
If the receiver was switched on by the video recorder timer,
this will be indicated by “ VCR Timer” being shown on the
display. Most of the remote control functions are disabled in
36
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 36