Filter
Top Products
8.4.2 Satellite scan
UTo scan a specific satellite for programmes, select the
option Satellite scan (Fig. 8-16). You can select whether you
wish to scan for all programmes (free-to-air and encrypted) or
only for free-to-air programmes.
> Press the OK key again to open the selection table of
active satelites.
> Use the up/down arrow keys to mark the line All
satellites to scan all active satellites for programmes,
or mark the desired satellite to scan only this for pro-
grammes.
> Confirm by pressing OK.
> Use the up/down arrow keys to mark the field Scan
mode.
> Use the OK key to select whether you wish to scan
only for free-to-air programmes (Free programmes) or
whether you wish to include encrypted programmes
(All programmes).
> Press the red function key Start scan.
The scan will be started. Please note an y messages
displayed on screen.
>You can stop the scan at any time by pressing the red
function key.
8.4.3 Transponder scan
You may scan a specific transponder (see Point 10 Technical
terms) for programmes. To do this, you will have to enter the
transponder data (Fig. 8-17).
Satellite
In this line, select the satellite on which the desired transpon-
der is located.
> Use the up/down arrow keys to mark the line
Satellite.
> Press OK to display a table showing the active satelli-
tes.
> Now use the up/down arrow keys to mark the des-
ired satellite.
> Confirm by pressing OK.
The selected satellite will now be indicated in the line
Satellite.
Transponder frequency
> Use the up/down arrow keys to mark the line
Transponder frequency.
> In this line, use the numeric keys to enter the appro-
priate frequency.
Symbol rate
The symbol rate indicates the volume of data transmitted per
second. A typical figure might be, for example, 27500 (27500
52
(Fig. 8-17)
(Fig. 8-16)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 52