Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-29
Example
AT+CCFC=?
+CCFC: (0-5)
OK
AT+CCFC=0,3,"01256316830",129,1
OK
AT+CCFC=1,3,"0545658278",129,1 //Register UC forward-to of all classes.
OK
AT+CCFC=1,1 //Activate UC forward-to of all classes.
OK
AT+CCFC=1,2 //Interrogate reason not-reachable of all classes.
+CCFC: 1,1,"+97254151200",145
+CCFC: 0,2,"",0
+CCFC: 0,4,"",0
OK //For <reason>=3, forward only voice calls is activated.
AT+CCFC=4,2 //Interrogate reason all-call-forwarding for all classes.
+CME ERROR: no network service //Interrogation of <reason>=30 is not supported by network.
AT+CCFC=2,3,"+972545658278"
OK
AT+CCFC=2,0 //Disable call-forwarding for reason no-reply of all classes.
OK
AT+CCFC=2,2
+CCFC: 0,1,"+972545658278",145,,25
+CCFC: 0,2,"+972545658278",145,,25
+CCFC: 0,4,"+972545658278",145,,25
OK
+CLIR, Calling Line Identification Restriction
This command instructs the G24-L to query, enable or disable the presentation of the CLI (calling
line ID) of a MO call to the called party. The restriction of the CLI (disable presentation) is
dependent both on the G24-L and on the network.
The network enables three possible provisions of CLIR:
• Not provisioned (CLIR Off - presentation allowed)
• Provisioned permanently
• Provisioned with Temporary mode
The provision is fixed and cannot be changed by an AT command.
Temporary Mode:
Temporary mode can be in one of two states:
• A - Presentation restricted (CLIR On) as default.
• B - Presentation allowed (CLIR Off) as default. A subscriber to Temporary mode always has
a default subscription to state A or B. Temporary-mode provisioning means that the terminal
can request the G24-L to switch the default mode from A to B, and vice versa.
