Filter
Top Products
23
AXIS P7701 - Sequence Mode
Sequence Mode
The AXIS P7701 displays the video from the connected sources in 2 different sequence modes - auto mode and manual mode.
Auto sequence mode
In this mode, the video sources in the list on the Video Sources page are automatically cycled through, one by one. Auto mode
can be paused and resumed by pressing the Video Select button.
Connection established Video source displayed.
Connection to currently playing
source is lost. Screen goes blank and, depending on the remaining display time, the
decoder either tries to reconnect or goes to the next source. The source
cache is cleared, resulting in a new autodetection. See also Adding a
video source, on page 10.
Video select button is pressed during display. Automatic cycling is paused.
Video select button is pressed during pause. Automatic cycling is resumed directly a
t the next source.
Parameters are changed. The connection cache is cleared and all sour
ces are autodetected again
upon the next connection.
User presses Connect to button in web interface to connect
to
a video source not included in the auto mode list.
The decoder connects to that source. After the display time has
elapsed, the next source in the auto list is selected.
Alarm received from video encoder or camera. Alarm is ignored.
Manual sequence mode
When in manual mode, the AXIS P7701 displays a single video source and only skips to the next source when the video select
button is pressed.
Connection established Video source displayed.
Connection to currently playing
source is lost. The screen goes blank and the decoder attempts to reconnect. The
source cache is cleared, resulting in a new autodetection.
Video select button is pressed during display. Decoder cycles to next source. If the next s
ource is not already cached,
autodetection will occur.
Video select button is pressed during autodetect of next
sou
rce.
Autodetect is aborted on that source and the decoder attempts to go
to the next source.
Parameters are changed. The connection cache is cleared and
all sources are autodetected
again, upon the next connection.
User uses Connect to button in web interface to connect to
a video
source not included in the manual mode list.
The decoder connects to that source. When the video select button is
pressed, the next source in the manual mode list is selected.
Alarm notification received from video encoder or camera. Decoder switches to display from the encoder or camera that sent the
ala
rm.
Note: Keeping the video select button pressed for more than 2 seconds will disconnect the AXIS P7701.
Action/event Result in auto sequence mode
Action/event Result in manual sequence mode