Filter
Top Products
Connection 23
4. Connection
When connecting a signal source to the projector, be sure to:
1. Turn all equipment off before making any connections.
2. Use the correct signal cables for each source.
3. Ensure the cables are firmly inserted.
In the connections shown below, some cables may not be included with the projector (see
"Shipping contents" on page 10). They are commercially available from electronics stores.
Connecting a computer
The projector provides VGA and DVI input sockets that allow you to connect it to both
IBM® compatibles and Macintosh® computers. A Mac adapter (an optional accessory) is
needed if you are connecting legacy version Macintosh computers.
To connect the projector to a notebook or desktop computer (either through a VGA
cable or VGA to DVI-A cable):
The final connection path should be like that shown in the following diagram:
Many notebooks do not turn on their external video ports when connected to a projector.
Usually a key combo like FN + F3 or CRT/LCD key turns the external display on/off. Locate a
function key labeled CRT/LCD or a function key with a monitor symbol on the notebook. Press
FN and the labeled function key simultaneously. Refer to your notebook's documentation to
find your notebook's key combination.
•With a VGA cable: •With a VGA to DVI-A cable:
1. Take the supplied VGA cable and
connect one end to the D-Sub output
socket of the computer.
2. Connect the other end of the VGA
cable to the D-SUB IN signal input
socket on the projector.
1. Take a VGA to DVI-A cable and
connect the VGA end to the D-Sub
output socket of the computer.
2. Connect the DVI end of the VGA to
DVI-A cable to the DVI-I signal input
socket on the projector.
3. If you wish to use the remote paging function (see "Remote paging operations" on
page 56), take a USB cable and connect the larger end to the USB port of the
computer, and the smaller end to the USB socket on the projector.