Filter
Top Products
54 Operation
Creating your own startup screen
In addition to selecting the projector preset startup screen from among BenQ logo or Blue
screen, you can make your own startup screen that is a picture projected from your
computer or video source.
To create your own startup screen, project the picture you want to use as your startup screen
from either a computer or video source. The rest steps are as follows.
• Using the remote control
1. Press CAPTURE on the remote control.
2. A confirmation message displays. Press
CAPTURE or ENTER again.
3. The message 'Screen Capturing...' displays while
the projector is processing the picture. Please
wait.
4. If the action is successful, you see the message
'Captured Succeeded' on the screen. The
captured picture is saved as My Screen.
5. To view the captured picture displayed as the
startup screen, set My Screen in the System Setup
> Splash Screen menu and restart the projector.
•Using the OSD menu
1. Press MENU and then press / until the
System Setup menu is highlighted.
2. Press to highlight My Screen and press
ENTER.
3. Repeat steps 2-5 in the “Using the remote
control” section to capture and view the captured
picture.
In the unlikely event that the capturing action fails,
change your target picture.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Rename User Mode: See "Renaming user modes" on page 44 for details.
• Menu Display Time in the System Setup > Menu Settings menu sets the length of time
the OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments. Use / to select a suitable time.
• Menu Position in the System Setup > Menu Settings menu sets the OSD position in five
locations. Use / to select a preferred position.
• Language in the System Setup menu sets your familiar language for the On-Screen
(OSD) Menus. See "Using the menus" on page 31 for details.
• Splash Screen in the System Setup menu sets a preferred logo screen to be displayed
during projector start-up. See "Creating your own startup screen" on page 54 for details.
Language
Splash Screen
My Screen
Projector Position
Blank Timer
Auto Off
Sleep Timer
Background Color
Menu Settings
Input Source
System Setup
Analog RGB
English
My Screen
Disable
Auto Source Search
EXIT Back
Disable
Disable
Blue
On
Floor Front
ENTER