Filter
Top Products
Operation 33
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right displays
lasting for three seconds, and the Input Password page
follows. You can retry by entering another six-digit
password, or if you did not record the password in this
manual, and you absolutely do not remember it, you
can use the password recall procedure. See "Entering
the password recall procedure" on page 33 for details.
If you enter an incorrect password 5 times in
succession, the projector will automatically shut down
in a short time.
Entering the password recall procedure
1. Press and hold AUTO on the projector or
remote control for 3 seconds. The projector will
display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.
Changing the password
1. Press MENU on the projector or remote control and then press / until the
Advanced Setup menu is highlighted.
2. Press / to highlight Password and press ENTER. The Password page displays.
3. Highlight Change Password and press ENTER. The Input Current Password page
displays.
4. Enter the old password.
• If the password is correct, the message 'Input New Password' displays.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'Input Current Password' displays for your retry. You can
either press MENU to cancel the change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your
selected password down here in this manual in advance or right after the password
is entered so that it is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
Password Error
Please try again.
Please write down the recall code, and contact
your local BenQ Customer Center.
Recall code:
0 2 1 2
Recall Password
Back
EXIT