Filter
Top Products
Operation 61
Picture -- Basic menu
FUNCTION
(default setting/
value)
DESCRIPTION (default setting/value)
Picture Mode
(Analog RGB/
DVI-A/DVI-D/RJ-
45
:
Presentation;
S-Video/
Component/
Video
: Standard)
Pre-defined picture modes are provided so you can optimize your
projector picture set-up to suit your program type. See "Selecting a
picture mode" on page 42 for details.
Load Settings
From
Selects a picture mode that most suits your need for the picture quality
and further fine-tune the picture based on the selections listed below.
See "Setting the User 1/User 2/User 3 mode" on page 43 for details.
Brightness
(depends on the
selected input
source)
Adjusts the brightness of the picture. See "Adjusting Brightness" on page
45 for details.
Contrast
(depends on the
selected input
source)
Adjusts the degree of difference between dark and light in the picture.
See "Adjusting Contrast" on page 45 for details.
Color
(depends on the
selected input
source)
Adjusts the color saturation level -- the amount of each color in a video
picture. See "Adjusting Color" on page 45 for details.
Tint
(depends on the
selected input
source)
Adjusts the red and green color tones of the picture. See "Adjusting Tint"
on page 45 for details.
Sharpness
(2)
Adjusts the picture to make it look sharper or softer. See "Adjusting
Sharpness" on page 45 for details.
Reset Picture
Settings
Returns all settings in the Picture -- Basic and Picture -- Advanced
menus to the factory preset values. See "Resetting the picture mode" on
page 44 for details.
Rename User
Mode
Renames User 1, User 2, or User 3. See "Renaming user modes" on page
44 for details.