Filter
Top Products
52 Operation
PIP (Picture In Picture) operation
To display the PIP window:
• Using the remote control
Press PIP to display the PIP page and make adjustments
by following the steps starting from step 3 in the section
‘User the OSD menu’ below.
•Using the OSD menu
1. Press MENU and then press / until the
Display menu is highlighted.
2. Press to highlight PIP and press ENTER. The
PIP page displays.
3. Highlight PIP and press / to select On.
The projector will select two currently active signals to
display and the last viewed picture will be displayed on
the big screen as a main source.
See "Split Screen and PIP source conflict list" on page
53 for the conflict source combinations.
4. To change the Main Source or Second Source,
press to highlight Main Source or Second
Source and press ENTER. The source selection
bar displays.
5. Use / to highlight the source you want to
display for the main (bigger) or second (smaller)
window, and press ENTER to save the setting and
go back to the PIP page.
6. To make OSD settings to one of the two sources
(main or second), highlight Active Window and
press / to select the source you want to
make adjustments.
The settings made on the OSD menus will
only take effect on the active window. See
"Disabled functions for the active windows" on
page 53 for exceptions.
7. To change the position of the smaller picture,
highlight Position and press / repeatedly
until a suitable position is selected.
8. To resize the small picture, highlight Size and
press / to set the PIP size among Small or
Large.
9. To save the settings and leave the OSD menu,
press MENU once or EXIT repeatedly until the
menu disappears.
Aspect Ratio
Digital Screen Shift
Keystone
Position
Overscan Adjustment
Digital Zoom
Pan
PIP
Split Screen
PC & Component YPbPr Tuning
Display
EXIT Back
0
0
100%
Analog RGB
ENTER
PIP
PIP
Main Source
Second Source
Active Window
Position
Size
On
Main
Top-Right
Large
EXIT Back
Fill
Attachable Lens
Off