Filter
Top Products
Connection 27
Connecting a Component Video source device
Examine your Video source device to determine if it has a set of unused Component Video
output sockets available:
• If so, you can continue with this procedure.
• If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to a Component Video source device through a
Component Video cable:
1. Take a Component Video cable and connect one end to the Component Video output
sockets of the Video source device. Match the color of the plugs to the color of the
sockets; green to green, blue to blue; and red to red.
2. Connect the other end of the Component Video cable to the COMPONENT sockets
(Y, Pb/Cb, Pr/Cr) on the projector. Match the color of the plugs to the color of the
sockets; green to green, blue to blue; and red to red.
The final connection path should be like that shown in the following diagram:
• Component Video is the only video input that delivers native 16:9 aspect ratio picture.
• If the selected video picture is not displayed after the projector is turned on and the
correct video source has been selected, check that the Video source device is turned on
and operating correctly. Also check that the signal cables have been connected correctly.
AV device
i. Component cable
i