Filter
Top Products
Configuring a failover server
Main window > Devices tab > > General > VRM Settings tab
VRM service is running on the master and on the failover server.
Both master and failover server must have the same VRM version.
Proceed as follows to configure a master and a failover server:
1. On the master server, create a failover group and a failover user with corresponding
password. The name of each the group and the user must be backup. The group should
not have any rights.
2. Select the failover server and click the VRM Settings tab.
3. Click to check Use as failover server.
4. In the Master server IP address field, type the IP address of the master server.
Click the green arrow to display a list of available VRM Servers. You can select an entry.
5. In the Password field, type the password for the failover user.
6.
Click .
In normal operation, the failover server is passive.
Notice!
To check the connection between master and failover server, connect to the master server
using VRM Monitor and check whether the Failover server connected to master server. entry
is listed in the log.
See also
– VRM Settings tab, page 30
9
Video Recording Manager Configuring a failover server | en 23
Bosch Sicherheitssysteme GmbH 2013.01 | v1 | DOC