Filter
Top Products
Defaults
Sets the storage system back to its factory default. Additionally to clear the storage system
name and all iSCSI IP addresses are deleted. Only management addresses and the
configuration password are retained.
Serial number
The serial number needed for support cases. It is only correct if the controller is not moved to
a different shelf.
Delete all LUNs
As already stated above the user should wait some hours before he creates new LUNs.
Additional information
Additional information is displayed here, for example information that the storage system is
not configured correctly and that therefore no setup is possible.
Load Balancing tab
Main window > Devices tab > Expand > Expand Pool n > Expand Storage
Systems > Desired iSCSI device: > Load Balancing tab
Set the upper limits for the permitted bit rate and the number of simultaneous iSCSI
connections for each iSCSI system. If these limits are exceeded, data is no longer being
written to the iSCSI system and is lost.
For supported systems (for example Bosch RAID, DSA, DLA), use the default values. For
another device see the documentation of this device. Start testing with small values.
Prerequisite: Configure the Automatic recording mode.
Hard limit
These values represent a security margin in relation to the soft limit values. If the write
accesses are in this range, internal allocation of addressed blocks must be reorganized. This
does not affect the current recording.
If this value is also exceeded, the recording is interrupted for a few seconds and the internal
allocation of addressed blocks is reorganized.
If the system as a whole does not provide sufficient bandwidth or iSCSI connections for the
allocated devices, this can result in recordings being impossible on a regular basis. If this is
the case, increase the available overall bandwidth and/or the number of possible iSCSI
connections by adding further storage systems, or reduce the number of cameras recording on
the iSCSI system.
Failover VRM Server information
Main window > Devices tab > > General > Unit Access tab
Failover VRM Server information
IP address failover server
For Archive Player only: Type the IP address of the failover VRM that you have configured on
the VRM Settings tab. This ensures that Archive Player has access to the recordings of the
failover VRM.
See also
– Configuring a failover server, page 23
11.3.3
11.4
Video Recording Manager User interface | en 29
Bosch Sicherheitssysteme GmbH 2013.01 | v1 | DOC