Filter
Top Products
Entry in the Type list Available configuration settings
RTSP Select for adding a 3
rd
party camera that supports the
Real Time Streaming Protocol.
JPEG Select for adding a 3
rd
party camera that can send JPEG
images (usually every CCTV camera).
In the Rate [ips] list, select the desired value.
Table 11.1: Protocol settings
VSG Camera Name
Change the camera name if required. This name is used for VRM and for Bosch Video Client.
See also
– Adding a Bosch camera to a VSG, page 20
– Adding an ONVIF camera to a VSG, page 21
– Adding a 3rd party camera to a VSG, page 21
Recording profiles tab (Video Streaming Gateway)
Main window > Devices tab > Expand > Expand Pool n > Expand Devices >
Video Streaming Gateway device > Recording tab > Recording Profiles tab
Allows you to switch recording on or off for each VSG camera.
Recording
In the list, select the desired entry.
See also
– Switching on recording, page 22
Multicast tabs (Video Streaming Gateway)
Main window > Devices tab > Video Streaming Gateway device > Network tab >
Multicast tab
Allows you to configure multicast for the assigned cameras.
Enable
Click to enable multicast for this camera.
Multicast Address
Insert a valid multicast address (in the range 224.0.0.0 - 239.255.255.255).
Type in 1.0.0.0. A unique multicast address is automatically inserted based on the MAC
address of the device.
Port
When a firewall is used, enter a port value that is configured as non-blocked port in the
firewall.
Streaming
Click to enable continuous multicast streaming to the switch. This means that the multicast
connection is not preceded by a RCP+ registration. The encoder streams always all data to the
switch. The switch in return (if no IGMP multicast filtering is supported or configured) sends
this data to all ports, with the result that the switch will flood.
11.17
11.18
38 en | User interface Video Recording Manager
2013.01 | v1 | DOC Bosch Sicherheitssysteme GmbH