Filter
Top Products
SETUP AND USE GUIDE
25
4 Use, if necessary, the Page Up or Page Down button to go to the next
button you want to ‘teach’.
5 Press the soft or hard button you want to ‘teach’ on the Avidea Remote.
The soft button will go from light to dark, and the Learn label changes to
Learning, which means the Avidea Remote is ready to receive commands
from an existing remote control. The Avidea Remote will wait for 5
seconds to receive an IR code from another remote control.
Note When a hard button is pressed to learn, there is no on-screen feedback to
indicate which button is pressed.
6 Press and hold the button on the existing remote control you want to
‘teach’ to the Avidea Remote.
When the Avidea Remote receives an IR code:
• You hear a confirmation beep.
• The label changes from Learning to OK. The Learn sequence has
been completed successfully.
For each Device you can ‘teach’ all soft and hard buttons on the Avidea
Remote, except for:
• the Backlight button
• the Page Up and Page Down buttons
• the Mode button
• the Device button
USING THE AVIDEA REMOTE