Filter
Top Products
SETUP AND USE GUIDE
35
MAINTAINING THE AVIDEA REMOTE
How do I reset the Avidea Remote?
Under normal circumstances, you will never have to reset the Avidea Remote.
However, on rare occasions, if the Avidea Remote’s touch screen freezes or if
you notice unusual behavior, you need to perform a reset to get the Avidea
Remote running again. All customized commands and Devices are retained,
however you will need to reset the time and date.
1 Remove the battery cover from the back of the Avidea Remote.
You will see the Reset button in the battery compartment.
2 Use an unfolded paperclip or
a sharp pencil to carefully
press the Reset button.
The Avidea Remote restarts and
beeps twice to indicate it is
ready for use.
How do I revert to the last downloaded configuration?
Reverting to the last downloaded configuration restores the Avidea Remote’s
Devices and commands to the state last downloaded from your PC. This
means that any changes made in the remote are lost permanently. Normally,
you never have to revert the Avidea Remote.
1 Press and hold the Mode button for 3 seconds.
The mode screen appears.
2 Tap the Setup button.
3 Press the Page Down button to access setup page 3.
4 Tap the Revert button.
A message screen appears to confirm or cancel the revert process.
5 Press OK or Cancel.
Do I have to calibrate the touch screen?
The Avidea Remote’s touch screen is calibrated when it leaves the factory.
You only have to calibrate the LCD touch screen:
• When you upgrade the Avidea Remote’s software in the future. The
Avidea Remote displays a message to calibrate the touch screen. Complete
the instr
uctions in ‘Calibrate the touch scr
een’ on p. 16.
•
When the touch scr
een buttons do not respond properly. Navigate to
Setup Mode first as described in ‘Adjusting the Settings’ on p. 14 and
continue with the instr
uctions in ‘Calibrate the touch scr
een’ also on p.
16.
Reset button