Filter
Top Products
dCS 904 User Manual Manual for Software Version 1.5x and 1.36
dCS Ltd June 2000
Manual part no: DOC135904 iss 2B2
Page 74
135904ma2b2.pdf file available from website
Contact
dCS
on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
T
ROUBLE
S
HOOTING
Error Codes and Messages
The error codes reported by dCS 904 provide an effective means to diagnose the
majority of problems that may be encountered in use - including problems with
the overall system the unit operates in, internal device warnings and internal
device failures. Please note that through damage or component failure, the unit
self check may fail to operate. If this happens, please contact your distributor or
dCS for assistance.
Internal Device Error Codes
Sometimes the unit may misbehave. If there is an internal reason, an internal
device error code may be displayed as follows:
Err.xy an error xy (see table below) has been detected
where xy values have the following meanings:
Code Description
01 E
2
memory (EEPROM) not present
02 Error initialising DSP
03 Error loading DSP
04 Error initialising DSP for coefficients
05 Error initialising DSP for coefficients
06 Error loading DSP coefficients
07 Error loading DSP coefficients
08 Error sending command
09 Error sending command
10 Error sending command
11 Error sending command
12 Error with LSB/MSB configuration
13 Error with LSB/MSB configuration
14 Error with LSB/MSB configuration
15 Error configuring FPGA
99 DSP error
Table 13 - Internal Error Codes
If you get any of these, please contact dCS, with as much information as
possible to help us re-create the problem. Some of these may have hardware
problems as their cause, some may have software.