Filter
Top Products
Figure 12. Inside the sled — 1.8 inch SSD system
1. system board 2. cooling shroud
3. cable cover 4. SATA cables (2)
5. DIMMs (8) 6. SSDs (8)
7. sled handle
Cable cover
Removing the cable cover
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
The sled is powered off when all the nodes are turned off.
2. Remove the sled from the enclosure.
3. Press the release latch on the cooling shroud, at the back of the cable cover, to disengage the cover
from the shroud.
4. Slide the cable cover toward the back of the sled.
5. Holding the cable cover by the edges, lift it up from the cooling shroud.
36