Filter
Top Products
The sled is powered off when all the nodes are turned off.
2. Remove the sled from the enclosure.
3. Locate the appropriate memory module socket(s).
4. Press the ejectors on the memory module socket outward to allow the memory module to be
inserted into the socket.
CAUTION: Handle each memory module only on either card edge, making sure not to touch
the middle of the memory module.
5. Align the edge connector on the memory module with the alignment key on the memory module
socket, and insert the memory module in the socket.
NOTE: The memory module socket has an alignment key that allows you to install the memory
module in the socket in only one orientation.
CAUTION: To prevent damage to the memory-module socket during installation, apply
pressure at both ends of the memory module evenly. Do not apply pressure to the center of
the memory module.
6. Press down on the memory module with your thumbs to lock the memory module into the socket.
Figure 18. Installing the memory module
1. memory module 2. memory-module ejectors
3. memory-module socket alignment key 4. memory-module alignment key
NOTE: When the memory module is properly seated in the socket, the ejectors on the memory
module socket align with the ejectors on the other sockets that have memory modules
installed.
7. Repeat step 4 through step 7 of this procedure to install the remaining memory modules.
8. Install the sled in the enclosure.
9. Turn on the sled.
10. (Optional) Press F2 to enter the System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the newly installed memory.
NOTE: If the value is incorrect, one or more of the memory modules may not be installed
properly. Check to ensure that the memory modules are firmly seated in their sockets.
11. Run the system memory test in the system diagnostics.
43