Filter
Top Products
76
Programming Your Remote Control
You may have already programmed your remote control during Guided Setup, but if you didn’t, or you
want to make changes, or you’ve acquired some new equipment, follow these instructions. You can pro-
gram the DIRECTV Remote Control to operate your TV power, volume and mute, additional equipment
such as a DVD, VCR, stereo, or second TV or DIRECTV Receiver.
1) Press MENU to display the Quick Menu.
2) Highlight Settings and press SELECT.
3) Highlight Setup and press SELECT.
4) Press SELECT on Remote in the left menu.
5) Follow the onscreen instructions to program your remote for your TV or additional equipment
(AV1 and AV2).
Once your remote is programmed to work with your TV, the VOL and MUTE key control the TV
regardless of the MODE slide switch position. If you would like to change the VOL and MUTE to work
with other audio equipment, such as a stereo, you can. When you program the remote for the audio
equipment, onscreen instructions will direct you on how to do this.
Factory Defaults
To reset the remote control and clear all but DIRECTV mode, follow these steps:
1) Point the remote away from your DIRECTV Receiver and components. Press and hold MUTE and
SELECT until the light above the slide switch on the remote flashes twice (about 5 seconds).
2) Enter 9-8-1. e light on the remote will flash twice, indicating you have cleared AV1, AV2 and
TV modes.
If you
programmed your
Remote Control
during Guided
Setup, you can
skip this section.