DirecTV HD DVR DVR User Manual


 
77
Using Your IR or RF Remote to Control Your DIRECTV Plus
HD DVR
You can skip this section if you do not have an RF Remote Antenna and RF Capable Remote (sold sepa-
rately) or you setup your RF Remote Control during Guided Setup. This information is included here if
you skipped that part, or if you want to change your Remote setup later.
The remote control included with your DIRECTV Plus HD DVR works using IR (infrared). IR is typical
of remotes you are already familiar with from other remotes you may have — the remote must be pointed
at the device for it to respond. If you have an RF Remote Antenna and RF Capable Remote, you can use
them to operate the DIRECTV Plus HD DVR without having to point your remote directly at it, such as
when the receiver is installed in a cabinet, or you use the remote from another room in your house. The
operating range of an RF Remote is up to 200 feet, with some possible decrease due to weak batteries or
obstacles such as walls in your house. Once programmed, your RF Remote will be addressed to only one
receiver, so will not affect other receivers in your home.
To setup an RF Capable Remote, press the MENU key, press SELECT on Settings, then select Remote
from the left menu. Press SELECT on the IR/RF Setup button. Follow the onscreen instructions to config-
ure your remote.
A remote that can
go through walls?
That’s right. It’s
the next best
thing to X-ray
vision.