Filter
Top Products
Page 8
Chapter 2
Parts of the System
R
EMOTE CONTROL BATTERIES
The remote control comes with AAA batteries. When you replace old batteries,
you should replace all of the batteries. Use batteries of the same kind, for
example alkaline or carbon zinc, and don’t mix batteries of different kinds.
Alkaline batteries last longer.
1. Press down on the top of the battery cover and slide the
cover off.
2. Take out all of the old batteries.
3. Put the new batteries in. Make sure you match the plus
(“+”) ends with the plus markings inside the battery case.
4. Fit the battery cover’s bottom tab back into the slot at the
bottom of the battery case, and slide the cover back into
place.
USING THE REMOTE CONTROL
The following section describes how to use the remote control with your
satellite receiver.
POWER BUTTONS
Press the POWER button to turn the receiver ON or OFF.
TV/VIDEO BUTTON
Use this button to switch the receiver between the satellite
programming and another video signal connected into the receiver’s
TV A
NTENNA/CABLE IN input, such as cable or broadcast TV
antenna input.
MENU BUTTON
Press this button to open the Main Menu.
PAGE UP AND PAGE DOWN (ARROW) BUTTONS
Press the PAGE UP button or the PAGE DOWN button to scan,
page by page, through the
Program Guide, a Theme Categories
list, a Favorite List, an Event Timers list, or a list of channels.