Filter
Top Products
Four-Channel Digital Video Recorder
19
System Check Screen
Highlight System Check in the Main menu and press the
button. The System Check setup
screen appears.
Figure 27 — System Check (Config.) screen.
Highlight the box under the On/Off heading and press the
button. This toggles between On and
Off. When it is On, the DVR reports a fault condition if it does not detect any recording or if there
is no alarm during the designated time.
Highlight the box under the Interval heading and press the
button. A slide bar appears allowing
you to set the check interval from 1 Hour to 30 Days.
The Status field displays Good when the DVR continues operating according to the user’s settings
without any problems, there was recording, or any alarm occurred during the designated time. The
Status field displays Bad when there was no recording, or no alarm occurred during the designated
time.
Highlight the Alarm Out / Notify tab and the System Check – Alarm Out / Notify screen
displays.