Filter
Top Products
101
D824/D1624 Reference Manual (Changing the Initial Settings <SETUP mode>)
Changing the Initial Settings (SETUP mode)
<Table-3> “Execution” menu
Execution item Display Refer page Community
Editing a program title Title Edit PGM** ? 37 -
Deleting a program Delete PGM** ? 36 -
Loading song data Load PGM ? 84 -
Saving song data Save PGM ? 84 -
Optimizing a Disk Disk Optimize ? 30 -
Formatting a Disk Disk Format ? 30 -
<Table-2> “Check” menu
Check item Display Refer page Community
Check of the Event number on the track NOs Of Event ? 118 -
Check of the current drive status Drive Info ? 119 -
<Table-1> “Changing the initial settings” menu
Parameters Display Default setting Refer page Community
Setting a time signature Signature Set ? 001bar 4/4 103
Setting a Tempo Tempo Map Set ? 001bar 1 120 105
Setting the metronome function Click ? Off 107
Setting a preroll time Preroll Time ? 00s 108
Setting MIDI sync output signal Midi Sync Out ? MTC 109
Setting an MTC frame rate Frame Rate ? 25 frame 109
Setting an MTC offset value MTC OFFSET 00h 59m 57s 00f 00sf 110
Setting Offset mode Offset Mode ? ABS 111
Setting a reference time code Ref. TC ? Void! Available with option Model 8345 (Refer to APPENDIX)
Setting the slave type Slave Type ? Vari 112
Setting the record protect function Rec Protect ? Off 112
Setting digital input tracks D. in? Analog 113
Setting digital output tracks D. out ? adat 114
Setting BAR/BEAT resolution mode Resolution ? Off 115
Setting the MIDI device ID number Device ID ? 00 116
Setting the operating clock Clock Sel ? Int. 117
Setting the SYNC preset Sync Preset ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the Virtual LTC display Virtual LTC ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the chase offset display Offset Disp ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the drive Drive Sel. ? IDE 121 -
Setting the internal clock Date & Time Set ? Please refer to the “Quick Operation Guide.”
: Modes applicable program by program. They can be saved/loaded.
: Modes applicable to all programs. They cannot be saved/loaded.
The SETUP mode offers the Changing the initial settings menus to configure the operating environment
of the recorder, a “Check” menu that enables you to check the number of events of each track and the
“Execution” menus to execute certain operations such as save/load and disk formatting.
The “Changing the initial settings” menus include 21 parameters as shown in <Table-1> below. These
parameters were set before the recorder was shipped from the factory and are called the initial settings.
By modifying these settings, you can change the operating environment of your recorder. The “Check”
menu provides two parameters as shown in <Table-2> : Checking the number of events and Checking
the current drive information.
The “Execution” menus in <Table-3> include six items: Title Edit?, Delete. PGM?, Load PGM?, Save PGM?,
Disk Optimize, and Disk Format?, which you can execute by selecting the corresponding SETUP menu.
In this chapter we will explain procedures only on <Table-1> “Changing the initial settings” menu (except
setting the internal clock) and <Table-2> “Check” menu. To learn how to set the internal clock, refer to
the “Quick operation guide,” and on the “Execution” menu, the “Reference page” written in <Table-3>.