Filter
Top Products
D824/D1624 Reference Manual (Names and Functions)
20
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
44.1kHz
REMAIN
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
44.1kHz
MTC IN
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
44.1kHz
SIGNATURE
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
44.1kHz
MTC
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
ABS time base
BAR/BEAT/CLK time base
MTC time base
4. Switching the Time Base display using the SHIFT key and DISP SEL key
When the screen is showing the ABS TIME or REMAIN display, if you press the DISP SEL key repeatedly while
holding down the SHIFT key, the TIME BASE display will change cyclically.
You can select one of the following Time Base displays.
MIDI
SAVE
LOAD
EXT SYNC
DIGITAL
This indication lights up when the recorder
receives effective MIDI message from an external
MIDI device.
When the recorder enters save function mode, the
selected parameter name will appear here.
When the recorder enters load function mode,
the selected parameter name will appear here.
This lights when a digital input track is set and a
digital signal is correctly input. It will blink if the
digital signal is not correctly input.
In other than [Int.], if the SETUP mode [Clock Sel ?]
menu is set to ([Auto], [Word], [Video]) and:
* data is loaded from adat/DAT, -
* the digital-In is set to [adat: Sync] or [SPDIF: Sync],
-
* the SETUP mode Slave Type is set to [Vari] and
Slave mode is set to ON, -
this will blink and charge to constant lighting when
the digital signal is correctly input.
If “BAR/BEAT/CLK” is selected for the time base
(explained later), the DISK REMAIN indication will
show a value (in terms of the number of measures)
calculated based on the last beat/tempo data on the
tempo map of the recorded song.
At this time if you press the DISP SEL key, the Disk
Remain display will appear. (Both recordable time
and hard disk capacity remaining will be converted
to mono track and expressed in time and megabytes.)
ABS TIME display
DISK REMAIN display
If you press the DISP SEL key again, the MTC IN
display will appear. If an optional Model 8345 TC/
SYNC card is installed, and the reference TC is
switched to [LTC], and an external TC is input, that
reference input LTC time figure will be displayed.
MTC IN display
3. Switching the display using the DISP SEL key.
Let’s assume that you turned off the power while the time display was using a time base of “ABS,” and then
you turned the power on again. The recorder time display will again use a time base of “ABS.” (Underline-
>Displayed program number)
If you press the DISP SEL key again, the screen will
return to the “ABS TIME” display.