Filter
Top Products
D824/D1624 Reference Manual (Storing a Locate Point (Edit Point)
55
2
4
3
Flashing
15
44.1kHz
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
1.While the recorder is stopped, press the memory
key that stores the data you wish to edit.
The stored data appears on the display and the recorder
enters data edit mode.
2.Turn the SHUTTLE dial to move the flashing cursor
to the time value digit, and use the JOG dial to
increase or decrease the value.
3.Press the STORE key.
The [Press LOCATE: ##] menu will appear as indicated
before. Ignore this go to the next step.
4.Press the memory key that you pressed in Step 1
again.
The STORE LED will turn off. The edited data is stored,
and the recorder displays the previous Time Base
indication.
• You can store the edited data in a memory key other
than the one you pressed when you recalled the data.
For example, you can recall the AUTO PUNCH IN point
data, edit it, and store it to the AUTO PUNCH OUT
key.
• You can also use the Preview function to edit the
stored locate points (edit points). Refer to “Preview
Function” on page “
63
” for more information.
• Refer to page “
39
” for more information on Auto
Punch In/Out.
• Refer to page “
66
” for more information on Copy &
Paste, Move & Paste, and Erase.
• Refer to page “
58
” for more information on Auto
Return and Auto Repeat.
Storing and editing LOCATE key
You can store up to 99 individual time data in the LOCATE key for Locate only operations.
The time data stored can also be assigned with a specific locate number from 01-99. This means
the desired locate number can be specified to locate that specific time data. The memory data of
the LOCATE key can also be edited in the same manner as the data in the Memory key. After
editing the data the LOCATE key can locate that point, or even be re-stored as data for other
Memory keys.
<Notes>
* The last data located with the Memory key or LOCATE key is constantly stored as LOCATE number 00. However,
this data is constantly replaced after every LOCATE command. Therefore, do not use Locate Number 00 for
independent Locate data.
* You cannot preview the data stored in the LOCATE key, though it is possible to preview data stored in other
Memory keys.
* If you use a time base that is not an ABS time, there is a need to priory switch to the desired time base using the
SHIFT key and EXECUTE/YES key.
* Any editing or storing of data for the LOCATE point is valid only for the program that is currently started up.
Storing in real-time
You can store the locate point (in the ABS, MTC, or BAR/BEAT/CLK Time Base) in real-time while the
recorder is playing.
1.Press the PLAY button to start playback.
2.Press the STORE key (the STORE LED lights up).
The memory number selection menu will appear, as
follows.