Filter
Top Products
37
D824/D1624 Reference Manual (Handling Programs)
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
44.1kHz
SETUP
42
∞
_
OL
0
87654321
30
24
18
12
9
6
3
161514131211109
1. Press the SETUP key while the recorder is
stopped, to put the system in the SETUP
mode.
The recorder enters SETUP mode, and displays the first
hierarchy of the SETUP menu that was displayed before
you turned off the power. The default setting is
[Signature Set ?] menu.
2. Turn the JOG dial to select the first hierarchy
of the [Delete PGM ** ?] (deleting a Program)
menu.
Alternatively, you can use the SHUTTLE dial.
3. Press the EXECUTE/YES key.
The display will change and [SURE?] will flash?
This indicates that the system is in the stand-by state to
delete a program that is currently started up.
To cancel the delete operation, press the EXIT/NO key
while [SURE ?] is flashing. Each time you press the button
or key, the recorder will return to a higher level in the
hierarchy, and finally exit SETUP mode.
4. Press the EXECUTE/YES key again.
When the recorder displays [Deleting...] and finishes
deleting the Program, the data of the next Program
number moves in, and its ABS time appears.
To check the REMAIN time and free space, press the
DISP SEL key to display the [REMAIN] indication after
the Program is deleted.
5. Press the EXIT/NO key, or STOP button.
Editing a Program title
You can name the Program as explained in the “Creating a new Program” section. You can also
change the title later by using the [Title Edit ?] menu in SETUP mode.
<Note>
You can edit the title of the selected Program before you select SETUP mode. You cannot select a Program after the
recorder enters SETUP mode. Be sure to select the desired Program using the steps explained in the “Using the
Program Change function” section.
1. Press the SETUP key while the recorder is
stopped, to put the system in the SETUP
mode.
The recorder enters SETUP mode, and displays the first
hierarchy of the SETUP menu that was displayed before
you turned off the power. The default setting is
[Signature Set ?] menu.
2. Turn the JOG dial to select the first hierarchy
level of the [Title Edit ?] ([?] flash.) menu.
The JOG dial to select the indication. The following
example assumes that the title of Program that can be
edited is Program 2.
Flashing
Flashing
Flashing
Flashing
Flashing