Filter
Top Products
JPEG2000 Stand alone DVR User Guide
- 39 -
[IP CONFIG SETUP]
Press ENTER to enter a selection. Use to move the cursor. Use [+] [-] or
J.Shuttle to change the value, and press ENTER to confirm the setting and exit the
selection. Use to go to another selection and repeat the previous steps.
1.[MAC ADDRESS]
Indicate the DVR’s MAC address. MAC address is not editable.
2.[IP ADDRESS]
Set up the DVR’s IP address.
3.[IP PORT]
Set up IP Port.
4.[GATEWAY]
Set up GATEWAY.
5.[SUBNET MASK]
Set up SUBNET MASK.
6.[DHCP SETUP]
Inditcate the DHCP mode is set to Manual or Automatic. When DHCP is set to
Automatic, you can not change any IP settings in this page. To turn off the
DHCP automatic detection, exit this page and go to DHCP SETUP to change
the setting.
[DDNS SETUP]
1.[DDNS ON/OFF]
Press ENTER to turn ON and OFF the function.
2.[DNS SERVER]
Set up DNS Server’s IP address. Press ENTER to enter the selection. Use
to move the cursor and [+] [-] or J.Shuttle to change the value. Press
ENTER to confirm the settings and exit the selection.
3.[INTERVAL]
Set up an interval for the DVR to report its IP address to the DDNS server
automatically. (D- day / H- hour / M- minute). Press ENTER to enter the
selection and [+] [-] or J.Shuttle to change the value. Press ENTER to confirm
the settings and exit the selection.
4.[REGISTER]
Connect to DDNS server and register the DVR information to the server. Press
ENTER to start the registration.
5.[DNS STATUS]
Indicate the current status of DDNS connection
IP ADDRESS: Indicate the current IP address recorded in the server
IP PORT: Indicate the current IP port recorded in the server.
REMAIN TIME: Indicate the remaining time to report to the server.
6.[LAST REGISTRATION DATE]
Indicate the time of the last registration.
DDNS IP: 59.124.143.151