Jwin JD-VD503 DVD Player User Manual


 
VIDEO
COMPONENT
VIDEO OUT
S-VIDEO
OPTICAL COAXIAL
5.1CH SURROUND
AUDIO OUT
MIXED
AUDIO OUT
VIDEO
COMPONENT
VIDEOOUT
5.1CHSURROUND
AUDIOOUT
MIXED
AUDIOOUT
12
1. Normal connection
Connect with TV
Use the YUV cords to connect the player with the
corresponding ports of the TV set as shown in the
picture on the .right
2.Connect with S-Terminal
Connect one end of S-Terminal wire with S-Terminal
output socket on this player back-panel and another
with the S-Terminal input socket of the TV, and then
connect audio wire with the TV.
3.Connect with YUV (Y Cb Cr) Terminal
Connect one end of YUV wire with the Y, Pb/Cb, Pr/Cr
socket on the disc player and another with the corresponding
Y, Pb/Cb, Pr/Cr socket of the TV. And then connect
audio wire with TV. See picture at right.
When you connect the progressive scan TV, press the
PROGRESSIVE button on the remote control and if
no picture displays on the screen after DVD player
loads the discs, switch the video mode of the TV to
progressive scan and obtain the picture.
Notes: For normal TV, if you press the PROGRESSIVE
button on the remote control, no picture displays on
the screen; press PROGRESSIVE button again and
it will shift to interlace scan mode. Then all information
will resume factory settings after pressing the RECALL
button.
R