Filter
Top Products
45
206-4263
Teach To TV
UPDATING...
Do not unplug!
50%
Teach To TV (TLX)
Previous OK
xxLY750H-UA00005.TLX
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Diagnostics
Teach To TV (TLL)
Teach To TV (TLX)
Previous OK
Note: The Diagnostics option in
this menu is for service use only.
(Continued from previous page)
3. If applicable (see also “Before You Begin” on previous page), make sure to
assign the appropriate Zone designation(s) in the Target TV at this time.
Note: In order for the proper location-specic TV Zone and/or
Wi-Fi Zone prole data to be applied, the Zone designation(s)
must be assigned in the Target TV(s) BEFORE Teaching is
performed.
4. Insert the USB memory device that contains the FTG Conguration le into
either of the TV’s USB ports.
5. Press MENU SETTINGS on the Installer Remote to display the TV setup
menus (TV is in Pass-through Mode) or the Function Menu (TV is already in
FTG Mode).
6. Use the arrow navigation keys to select/highlight either the Option menu
icon from the TV setup menus or the Lock menu icon from the Function
Menu. Then, press the number “7” key a total of seven times to display the
USB Download Menu.
7. With the USB Download Menu on display, use the Up/Down arrow keys to
select Teach To TV (TLX), and then press OK.
8. In the Teach To TV (TLX) window, use the Up/Down arrow keys to select
the FTG Conguration le you want to install.
Note: Filenames for TLX les that were Learned from a TV are comprised of
the TV model and a ve-digit number, for example, xxLY750H-UA00005.TLX.
9. Press OK when you are ready to initiate the Teaching process.
Teaching status will be shown on a progress bar in a new window. Do NOT
remove the USB device until Teaching is complete. When the Teaching
process is complete, the TV will briey display a “Teaching Completed”
window and then exit the USB Download Menu.
10. Remove the USB memory device from the Target TV, and verify that the
FTG Configuration is resident on the Target TV.
Note: If it was previously in Pass-through Mode, the Target TV CPU is now in
FTG Mode.
After the Teaching process is complete, the TV tunes according to the Start
Channel setting in the Installer Menu. If a Start Channel is specied, the TV will
tune to that channel, though a channel banner will only be displayed if the Start
Channel is included in the FTG Channel Map; otherwise, the TV will tune to the
rst channel in the FTG Channel Map.
FTG Mode of Operation (Cont.)