LG Electronics 32LY750H CRT Television User Manual


  Open as PDF
of 84
 
55
206-4263
IP Environment Setup (Cont.)
Network Connection
Wireless network is connected.
Complete
Wireless : NetworkName
TV Gateway DNS Internet
MAC Address : AA:BB:CC:DD:EE:23 Gateway : 10.10.10.10
IP Address : 10.2.3.4 DNS Server : 10.5.6.7
Subnet Mask : 255.255.255.0
(Continued on next page)
2. Follow the on-screen instructions to complete the appropriate
network conguration. Use the Installer Remote navigate elds
and make entries, etc.
Once you have specied conguration details as necessary,
the TV will attempt to connect to the network and you will
see a progress screen that indicates status as each network
element is conrmed (see example at right). If the network is
connected successfully, a “Wireless network is connected”
message will be displayed at the top of the screen and the
network conguration data will be displayed in the lower half
of the screen.
3. Select Complete (if not already selected), and then press OK
on the Installer Remote to exit the Network Connection wizard
and return to the IP Environment Menu.
Note: If the network connection is not successful, the progress
screen will identify the network element in which the connection
failed. Check your cabling and/or, if necessary, press on the
Installer Remote to return to previous screens to verify the
conguration data.
Network Status
This option enables you to check the status of the network connection.
Note: If both wired and wireless network connections were congured in a previous
session in the IP Environment Menu, and a LAN cable is connected/detected between
the TV and the network, the Network Status operation rst will attempt to connect to the
network via the wired connection. If a wired connection is not detected, the Network
Status then will attempt a wireless connection, if one has been congured. On the other
hand, if, during the current session, you congured rst a wired and then a wireless
network connection, the Network Status operation will rst attempt to connect to the
network via the wireless connection (i.e., the last connection congured).
1. With the IP Environment Menu on display, use the arrow keys on the Installer Remote
to select Network Status. Then, press OK.
(Continued from previous page)
Note: Make sure you have the network security password/PIN available if you are
attempting to connect to a secured network.
Note: (AP List and Enter the SSID options only) As with a wired connection, a second
Network Connection window will enable you to specify the IP and DNS conguration for
this network connection. Auto (DHCP) tabs will be selected by default. If a DHCP server
is congured and a static conguration is not required, you can simply select OK (on the
screen) and then press OK on the Installer Remote. The DHCP server will assign an IP
address and DNS server to the TV for this network connection once the TV successfully
connects to the network. Otherwise, use the arrow keys to select the Static tab(s), and
specify the static conguration data for both the IP and DNS modes. When all elds are
completed, select OK (on the screen) and press OK on the Installer Remote.
 previous next