Filter
Top Products
18
206-4227
(Continued from previous page)
Use the Network Configuration Menu commands indicated below and follow the system
prompts to configure the port(s). See “Configure Network Settings” on pages 22 to 25
for further information.
b) Use the “eth0” and “dns” commands to congure the Control Port, as necessary.
c) Use the “eth1” command to congure the Feature Port, if required, for PCS200R IP
output.
Note that the Feature Port MUST be congured with a static IP address that is on a
different subnet than the Control Port IP address. Also, make sure the Feature Port
speed (default: 1000 Mbps) is appropriate for your system. If necessary, at the prompt
for the port speed, change the value to 100 Mbps.
d) When you are nished with network conguration, type exit at the Network Conguration
Menu
>
prompt. The system will display an overview of the new network conguration
and then prompt for conrmation to save the changes:
Do you want to save the new configuration? [y/n]:
Type y or n and press Enter, as appropriate.
Note: Review the New Network Configuration overview carefully before you confirm the
configuration settings. Ensure each of the addresses was entered correctly.
Note: If you changed the conguration of the port(s), you will be prompted to reset the
system. You may wait to reset the system until you are directed to do so in step 13.
11. (Optional) Set the date and time on the PCS200R.
By default, the PCS200R is synchronized with an NTP server and congured for the US
Eastern time zone. If the PCS200R is connected to the Internet, the NTP client will
periodically update the time setting on the PCS200R. You can set the time zone as
required. If the PCS200R is not connected to the Internet, you also have the option to
disable NTP synchronization and specify date and time data manually.
Use the PCS200R “tz” and/or “time” commands (available from the
Command >
prompt),
as necessary, to set the date and time on the PCS200R.
• Use the “tz” command and follow the system prompts to change the time zone.
• Use the “time” command and follow the system prompts to change the NTP
conguration or manually congure the date and time parameters on the PCS200R.
See “Set the Time Zone” and “Set the Date and Time” on pages 25 to 28 for further
information.
Note: If you changed the time zone and/or the NTP conguration, you will be prompted to
reset the system. You may wait to reset the system until you are directed to do so in step 13.
System Setup (Cont.)
(Continued on next page)