LG Electronics PCS200R Home Theater Server User Manual


  Open as PDF
of 40
 
24
206-4227
PCS200R Conguration Options (Cont.)
(Continued from previous page)
7. If the port is NOT using DHCP, type the information requested at each of the following
prompts. Type each address in the format xxx.xxx.xxx.xxx, and press Enter after each entry.
Note: If the Feature Port is to be used for IP streaming, you MUST congure
the port with a static IP address that is on a different subnet than the Control
Port IP address.
This host IP address []:
Network mask []:
Gateway IP address []:
(Control Port conguration only)
Note: If you are currently conguring the Feature Port, you will not be prompted for a
gateway IP address, though you will be prompted for the port speed (see step 8).
8. (Feature Port conguration only) At the
Enter Speed 100 or 1000 [1000]:
prompt,
either press Enter to accept the default value in square brackets, or type “100” or “1000,”
as applicable, and press Enter to set the appropriate port speed (in Mbps).
9. Once you enter the gateway address (eth0) or the port speed (eth1), the system will
redisplay the Network Configuration Menu.
• To modify the conguration of the second Ethernet port, repeat steps 4 to 8.
• To modify the DNS conguration, continue with step 10.
• If no additional network conguration is required, go to step 11.
10. To change the DNS conguration, type dns and press Enter.
At each of the following prompts, type the information requested. Type each address in
the format xxx.xxx.xxx.xxx, and press Enter after each entry.
Configuring DNS
Primary DNS IP address []:
Secondary DNS IP address []:
Once you enter the secondary DNS IP address, the system will redisplay the Network
Configuration Menu. You can select another option to modify (see previous steps) or you
can exit as described below.
11. When you are nished with network conguration, type exit at the Network Conguration
Menu
>
prompt.
The system will display an overview of the new network conguration and then prompt for
conrmation to save the changes, for example:
New Network Configuration
Interface eth0
Host name: pcs200r
Using DHCP: YES
(Continued on next page)
 previous next