Filter
Top Products
21
206-4227
PCS200R Conguration Options
Log In to the PCS200R and Access the Main Menu
Note: The PCS200R must be connected to an IP network for SSH client access. For direct
access to the PCS200R Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ).
See also “Network and Communication Setup” on page 20 for further information.
If necessary, consult the system administrator to obtain the current “admin” user password
before proceeding. The default admin user password is “Password4Partners” (case-sensitive).
1. Establish communication with the PCS200R using an SSH client or via a direct connection
to the PCS200R Service Port.
Once communication is established, you should see a login prompt. (If the login prompt is
not automatically displayed, press Enter to refresh the screen.)
2. At the
login as:
prompt, type admin and press Enter.
3. At the
Password:
prompt, type the admin password and press Enter.
4. At the
Command >
prompt, either:
• Press Enter to display the PCS200R Main Menu (see example below).
• Type the desired command and press Enter.
The following sections describe each of the configuration commands.
Note: You can always press Enter at the
Command >
prompt to display the PCS200R Main
Menu.
Example: PCS200R Main Menu
---------
Main Menu
---------
info System information
setip TCP/IP Setup Menu
tz Timezone setup
time Time setup
pwd Change password
monitor System monitor
format Format drive to ext3 file system
update Update
updser Update via serial link
vpn VPN setup
shut Shutdown the system
reset System Reset
exit End the session
Command >