Filter
Top Products
35
206-4227
Troubleshooting
PCS200R Setup
The following sections provide basic troubleshooting information for the PCS200R.
Equipment Setup Review
• Make sure all connectors and connections are tight and secure on all entertainment system
components.
• Check the PCS200R LED. Under standard operating conditions, i.e., when the PCS200R
is booted and operating normally, the PWR (Power) LED on the PCS200R front panel is
continuously lit green. If there is a hardware fault, the PWR LED will turn and stay red.
Note: When power is rst applied to the PCS200R, the PWR LED initially flashes red and
then turns green (blinking during boot-up).
Network Setup
If the network is configured for DHCP but the PCS200R has not been assigned an IP
address, i.e., the Ctrl IP field in the PCS200R System Information display is blank:
1. Check the Control Port connector on the rear panel of the PCS200R. Make sure the
cable connection is tight and secure.
2. Observe the green LED on the Control Port. Once the PCS200R is connected to the
network, the LED will be lit continuously.
3. Contact the network administrator to verify the network status and check that the DHCP
server is working properly.