Filter
Top Products
25
206-4227
PCS200R Conguration Options (Cont.)
(Continued from previous page)
Interface eth1
Host name: pcs200r
Using DHCP: NO
Host IP address: xxx.xxx.xxx.xxx
Network mask: xxx.xxx.xxx.xxx
Gateway IP address:
Speed: 1000Mbps
DNS servers
Primary DNS: xxx.xxx.xxx.xxx
Secondary DNS: xxx.xxx.xxx.xxx
Do you want to save the new configuration? [y/n]:
12. Type y or n and press Enter, as appropriate.
If you opt NOT to save the new configuration, the system will return immediately to the
Main Menu
Command >
prompt. Otherwise, the system will confirm the configuration
updates and prompt you to reset the system:
New configuration has been saved. Please restart the system.
13. If you are ready to reset the system immediately, at the
Command >
prompt, type reset
and press Enter (see “Reset the System” on page 32 for further information).
Note: If you intend to modify additional conguration settings during the current session,
you may wait until all changes are complete before you reset the system.
Set the Time Zone
Note: See “Set the Date and Time” on page 27 for information on setting the date and time
for the PCS200R.
1. Log in to the PCS200R as described on page 21.
2. At the
Command >
prompt, type tz and press Enter.
The system displays the current time zone information for the PCS200R and prompts you
to specify whether or not you wish to change the time zone.
Current time zone is: America/New York
Change the time zone? [y/n]:
3. Either:
• Type n and press Enter to return to the Main Menu
Command >
prompt without changing
the current time zone.
• Type y and press Enter to change the time zone. Then, continue with step 4.
(Continued on next page)