Filter
Top Products
32
206-4227
PCS200R Conguration Options (Cont.)
(Continued from previous page)
The system will display progress messages as well as the result of the update process
(which may take several minutes).
4. When the update is successfully completed, reset the system (see “Reset the System”
below for further information).
Shut Down the System
This command allows you to shut down the system in an orderly manner. Use this command
to shut down the PCS200R, for example, if you intend to physically move the unit from one
location to another. It is also recommended that you run this command from the PCS200R
Service Port in order to track detailed shutdown log messages.
Note: Once you use this command, you must remove power from (i.e., unplug) the unit and
then plug the AC power cord back into a powered AC line receptacle when you are ready to
restart the server. It is not possible to restart the server remotely.
1. Log in to the PCS200R as described on page 21.
2. At the
Command >
prompt, type shut and press Enter.
The system will prompt for conrmation:
Are you sure you want to shut down the system? [y/n]:
3. Either:
• Type y and press Enter to shut down the system immediately. The shutdown typically
takes about a minute. When the PCS200R is in its shutdown state, the front panel LED
will blink steadily green.
• Type n and press Enter to return to the Main Menu without shutting down the system.
Reset the System
1. If not already logged in, log in to the PCS200R as described on page 21.
2. At the
Command >
prompt, type reset and press Enter.
The system will prompt for conrmation:
Are you sure you want to reset the system? [y/n]:
3. Either:
• Type y and press Enter to initiate an immediate reset of the PCS200R. The reset process
may take up to two minutes, after which the system resumes normal operation.
• Type n and press Enter to return to the Main Menu without resetting the system.
Exit the Current Session
At the
Command >
prompt, type exit and press Enter to end the current session.