Filter
Top Products
Modes
The RC9500 has different “Modes”. When you activate the RC9500
for the first time, it starts up in USE mode allowing you to
immediately operate your devices. In USE mode, the center of the
LOWER TOOL BAR displays the MODE icon .Tap and hold
the MODE icon more than 3 seconds. The Mode Menu page
will appear. If the center of the LOWER TOOL BAR shows another
icon, like , tap it to reveal the Mode Menu and press the Left
Function button labeled “Exit” to return to USE mode.
Note If you do not see the Mode icon; it has been inactivated via the
Setup. To enable this function, the “Mode menu” setting in the
Setup has to be set to “On”. (see page 13)
Your RC9500 is capable of displaying hundreds of different control
pages. RC9500 presents you various ways to navigate easily to the
specific device and page.
Navigating the Devices
Home — The Home Page displays
convenient instant jump buttons that
navigate you to the main category pages
(View, Listen, Control).
Each category page has the buttons
that link to the most frequently used
devices in the home theater.
You can jump to the main control page
of your device by tapping the button
in the page.
Access the Home page by
pressing the HOME button at
the bottom left of the remote.
Note When you jump to a Device by tapping the device button in the
Category pages (except the Control), the RC9500 will change
the input of your home theater receiver/preamp.
User Guide
Getting Started
2. Navigating the RC9500
7
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 11