Filter
Top Products
Installing the Battery Pack
1 Press the latch on the battery cover and remove the battery
cover from the RC9500.
2 Plug the cable of the battery pack in the connector as illustrated.
3 Place the battery pack in the battery compartment.
4 Place the battery cover back on.
Note Make sure the cable of the battery pack does not get stuck
between the molded interior and the battery cover.
After a few seconds, the RC9500 starts up automatically and an
introduction screen appears. The RC9500 beeps twice to
indicate that it has finished starting up.
Because the battery pack of the RC9500 is not fully pre-
charged, you will have to charge it as described in the next
page.
User Guide
4
Introduction
1
2
3 4
DFU RC9500 Ver1_2.qxd 5/28/2004 10:32 AM Page 8